100 mbps in router

[peterp]

Sem instaliral Tomato RAF based in Original Tomato source code (tisti Tomato RAF 1.28.121006. This version guarantees WAN-LAN 80Mb throughput. For WRT54G/GS/GL.). V glavnem, prenos DL je max 56Mbit. Vse nastavitve default (tudi hitrost procesorja 188MHz), edina izjema je to, da je vključen multicast. Seveda pri benchmarku ni multicast prometa. Kako so dobili 80Mbit ne vem, mogoče z navijanjem procesorja in dodatnimi nastavitvami... Nimam pojma. No, pri meni gre recimo 10% hitreje kot default Tomato. Tako je pri meni.

[madpanter]

si dal clear nvram in reset? Možno je da so res malo navil procesor. Če boš to počel prilepi kako hladilno rebro na procesor.

[nemo]

Nobene potrebe ni po hladilnih rebrih. Jaz ga imam že od kar so dvignili hitrost navitega do konca (250 mhz) pa se niti malo ne segreva.

"So, at 250MHz, does it overheat? Does it explode? Does it somehow end up with a shortened life? No, the evidence is that it does not. Let me expand on this. I live in a country where the temperature is always over 30 degrees and often 40+ degrees. Because I have many routers running in many remote locations it is very important to me that they are stable. I've used these routers under full load over more than three years in full sun in enclosed cases with no ventilation, fans, or additional heatsinks. They don't overheat and there's really no need to add a heat sink, though if it makes you feel better and you know what you are doing, there's no harm in it. Adding fans is really quite pointless. Adding a fan means having holes in the enclosure, access to insects and lizards, problems with dust and dirt, and the need for maintenance on the fan itself. Kinda like shooting yourself in the foot.

However, there are a lot of zany people out there who want you to believe your 30 dollar router is some kind of advanced supercomputer and needs to be run by a nuclear reactor and cooled with liquid nitrogen One guy even has heaters and coolers and all manner of temperature sensors on his externally mounted WRT54GL. Another idiot has an Arctic PC CPU cooler towering out of a huge hole cut in the case."

iz: http://tomatousb.org/tut:overclocking-the-wrt54gl

[martis]

Jaz tudi imam WRT54 navitega na 250mhz, pa se samo malo greje, kaj šele, da bi se pregreval.

[zizitop]

Res je, prav je, da daš clear NVRAM:

Administration -> Configuration -> Restore Default Configuration -> Izbereš Erase all data in NVRAM memory (thorough) -> klikneš OK


Potem pa če je res potrebno, zvišaš takt procesorja. In res je, ne pregreva se niti na 250 MHZ, ker ta procesor je deklariran za 250 MHZ. Vseeno pa lahko probaš recimo razliko med 188 in 250. Morda je niti ni. Bi probla tudi sam, žal pa nimam take hitrosti.


LP

[_jure]

Hello

Ima kdo izkušnje s tem firmwarom in routerjem Buffalo WHR-HP-54? Overclockat ga ne gre, pa sem pomislil da bi poskusil z Tomato RAF 1.28.121006.

[madpanter]

no jaz sem na svojega dal rebra gor ker sem mel pač viška in so mi samo nesnago delal. zihr je zihr če ne drucga je bolj stabilno pa makar placebo efekt

[nemo]

Tako kot pravi oni zgoraj: "there's really no need to add a heat sink, though if it makes you feel better and you know what you are doing, there's no harm in it."

[PeterLynn]

Ali je mogoce kdo sprobal> TP-Link TL-WR1043ND, stiri gigabit porti, WiFi do 300 Mbit, pa cena tudi ni slaba <60 E
http://www.enaa.com/oddelki/racunalnist ... cni_router

Ga imam 4 mesece, zaenkrat zelo zadovoljen. Z računalnikom povezan po UTP kablu; tovarniški firmware; podpira tudi z DD-WRT firmware, ki ti da še dodatne funkcije, vendar boš izgubil garancijo.
Router je zelo stabilen in tudi domet wirelessa je soliden. Sicer so še boljši - za višjo ceno, a bo ta škatulja opravila svoje delo.

Še link do testa 10. routerjev za WAN->LAN prepustnost:
http://digitaldreamer.com.au/nbn-ready- ... for-speed/

[Vodokotlič]

Da ne bo kdo tople vode izumljal: http://www.smallnetbuilder.com/lanwan/r ... harts/view

[daman15]

kje se spremeni hitrost procesorja za wrt54gl-tomato.imam optiko 100/10 vleče mi 20-25.

[KoMar]

Prek telnet/SSH.

[nemo]

Jaz sem ga overclockal po teh navodilih: http://tomatousb.org/tut:overclocking-the-wrt54gl

[B3du1n]

Sem imel sam predhodno Linksys WRT54GL z ddwrt in je pesal na 100/10 liniji. Kasneje zamenjal z linksys E2000 tudi z ddwrt in povem da je razlika obcutna.

Res pa je, da je bil dosti ceneje predno je bil objavljen spodaj komentar na tej strani -> http://www.mimovrste.com/artikel/247004 ... ksys-e2000

Mislim, da sem ga takrat dobil za dobrih 50€...LP