P2P vrata

[Jaka]

Statični ip - privzeta nizka varnost

Iz statike pa mislim da ne moreš več na dinamiko

Tudi, če dobis napišem da bi rad spremenil iz nizke v visoko mi ne boste ugodili? A na statičnem ip se pa varnosti ne da spreminjat?

[lazyass]

2x , ampak če pogledaš, da poleg statike lahko uporabljaš 2 dinamična IP-ja in to da se stopnja vastnosti določa glede na priključek in ne glede na IP, bi bilo tehnično izvedljivo

[Jaka]

Jaz sem poslal dopis kar bo pa bo. Samo še nobenega odgovora nisem dobil.

[Malkec]

Ko imaš enkrat statiko, imaš statiko. Kar pomeni da ne moreš spremeniti varnostnega paketa, ker je na statiki privzeta nizka varnost.

Torej boš moral iskat rešitve pri sebi.

[Jaka]

Pol je edina rešitev da internet odjavim pa ponovno naročim.

[Malkec]

Torej nisi našel rešitve kako blokirat določene programe?

[Jaka]

Jaz imam bar v baru ponujam brezplačni dostop do interneta za stranke. Problem je ta da se je povečala poraba torrentov in tega nočem in se linija zabaše. Zato bi rad imel visoko varnost.

[Malkec]

Tole se da lepo v routerju omejit. Malo napiši kakšen hardware imaš in ti bomo pomagali.

[Jaka]

netgear wpn824v2

[Malkec]

To Create a New Inbound or Outbound Rule

1. Submit the router's address in an Internet browser. (The default is 192.168.0.1).
2. Enter the router's username and password.
3. From the main menu, click Security > Rules.
4. Click Add for inbound or outbound traffic, as appropriate to the application you are planning to run.
5. Select the Service. The services the router knows about are listed in the drop down. If the service you want is not listed, add it as described in the next section.
6. Select the Action, for example ALLOW always.
7. For Send to LAN Server, enter the IP address of the local server. Note that this is also the IP address the computers on your LAN will access.
8. For WAN User choose Any, or limit access to particular IP addresses.
9. For Log selection it is reasonable to turn logs on, especially at the beginning when you are unsure of the result of the changes you are making. Later, you may want to set logs to "Never" for performance reasons.
10. Click Apply.

Tukaj daš dvojni rule: Inbound all deny in outbound all deny. Za tem pa daš rule outbound port 80 allow always. Problem rešen.

Koliko si vešč konfiguriranja takih stvari?

[Jaka]

Tega jaz v router-ju nimam Click Add for inbound or outbound traffic, as appropriate to the application you are planning to run.

[Jaka]

Hvala za pomoč in trud. Bom že eno rešitev najdel, ki bo zame enostavna.

[Cobane]

Ne izumljaj tople vode! Daj enemu kolegu, ki se na to bolje spozna, za en pir (ali pa dva), pa ti bo nastavil.

[Jaka]

Bo že.

[Jaka]

Rad bi se zahvalil vsem zaposlenim na T-2, ker so mi rešili ta problem.